DC Servo Motor 8 Million Running Life Automatic Full Height Turnstile Mechanism core kit

DC Servo Motor 8 Million Running Life Automatic Full Height Turnstile Mechanism core kit

MOTOR DESCRIPTION

SINOMATIC new arrival servo control system is composed of a servo control main board, a voice module (optional), and a servo motor.

It has the following characteristics

1. FOC vector control technology.

2. Realize current loop, speed loop, position loop and three loop control.

3. On-board temperature control and voltage detection.

4. Using 1024 lines of magnetic weaving precision control, high precision and strong anti-interference.

5. Compared with traditional resistance sampling, the current loop adopts current sensor, which has higher stability.

6. The control board adopts all imported chips.

7. It has a variety of traffic modes to meet the needs of different occasions.

8. Infrared sensing technology realizes real-time monitoring of channels, safety protection and anti-tailing.

9. Reliable physical anti-pinch

10. Integrate RS485 to realize upper computer control

11. Real-time fault self-checking and alarm prompts ensure the safe operation of the system, which is convenient for maintenance and use.

12. With standard input and output interfaces, it is convenient for the system to integrate with other devices

13. Three pairs or four pairs of infrared sensor modes are optional(NOT for tripod turnstile and full height turnstile)

FULL HEIGHT TURNSTILE TECHNICIAL SPECIFICATIONS

STANDARD PACKING LIST

1 Motor Full height turnstile gate motor '

1 control board with RS485 port ;

2 pcs LED panel

1 pc air switching

1 power switching

Some installation metal accessories.

Turnstile Equipment Debugging Instructions

1. General Debugging Steps
Step 1: Pls connecting machines according to wiring diagram
Step 2: Power on, if there is error code, pls check error code and fix it
Step 3: Change the arm rotating direction from NP07 menu if incorrect.

Step 4: Set the zero position accordingly
Step 5: Adjust Position loop gain P by DP06 to adjust gate open speed

2.Common Debugging Issues
Issue 1: When you give signal to enter and exit, only open to one direction
Solution:
1) pls check NP01 value for the machine type
2) Open signal wiring is correct or not, pls make sure it’s not connected to Emergency open terminal

Issue 2: You want faster closing speed
Solution:
1) Increase Position loop gain P value by DP06 but make sure flap not overshoot
2) Increase Max operation speed value by DP01

Issue 3: Rotation arm overshoot
Solution:
1) Increase Speed loop gain P value by DP04
2) Decrease Position loop gain P value by DP06
3) Decrease Max operation speed value by DP01

Issue 4: Rotation not moving when power on and display E021
Solution: Pls check motor wiring, encoder wiring correct or not

Issue 5: Power on and display U-12
Solution: Power supply incorrect, pls check power supply